Differences

This shows you the differences between two versions of the page.

--- http_qcom [2023/05/11 20:46]
johnw [SaveCamera]
+++ http_qcom [2023/05/11 21:17]
johnw [SaveCamera]
@@ Line 857: / Line 857: @@
-==== SetIp ====
-=== local_ip ===
-IPv4 adresss
+==== SetIp ====
+----
-=== local_netmask ===
-IPv4 netmask
-=== default_gw ===
-IPv4 default gateway
-=== local_dnsip ===
-DNS server primary
-=== local dnsip2 ===
-DNS server secondary
-=== use_dhcp ===
-Controls use of DHCP or static IP
+Control networking settings of the Z3 device such as local IPv4 IP address, netmask, etc.
+Additionally control Encoder Auto-Start after boot-up and enable/disable showing of advanced WebUI settings.
-Possible values: 1 (DHCP enabled), 0 (DHCP disabled, use static IP)
+\\
-=== do_autostart ===
+== Parameters: ==
+----
+**//do_autostart//**
+Control automatic stream start after bootup.
+Possible values: 1 = do autostart 0 = do not autostart.
-Control automatic stream start after bootup
+**//enc_adv_setting//**
+Control appearance of advanced settings on WebUI.
+Possible values: off, on.
-Possible values: 1 = do autostart 0 = do not autostart
+**//ipmtu//**
+Control Ethernet IP Maximum Transmission Unit (MTU) size in bytes.
+Possible values: 576 to 1500.
-=== enc_adv_setting ===
+**//eth_speed//**
+Control Gigabit Ethernet auto-negotiation allowed speeds.
+Possible values: AUTO, AUTO-100, 1000, 100, 10.
-Control appearance of advanced settings on WebUI
+**//eth_duplex//**
+Control Ethernet auto-negotiation allowed duplex.
+Possible values: AUTO, FULL, HALF.
-Possible values: off, on
+**//local_ip//**
+IPv4 address.
-=== eth_speed ===
+**//local_netmask//**
+IPv4 netmask.
-Control Gigabit Ethernet auto-negotiation allowed speeds
+**//default_gw//**
+IPv4 default gateway.
-Possible values: AUTO, AUTO-100, 1000, 100, 10
+**//local_dnsip//**
+DNS server primary.
-=== eth_duplex ===
+**//local_dnsip2//**
+DNS server secondary.
-Control Ethernet auto-negotiation allowed duplex
+**//use_dhcp//**
+Controls use of DHCP or static IP.
+Possible values: 1 (DHCP enabled), 0 (DHCP disabled, use static IP).
-Possible values: AUTO, FULL, HALF
+**//local_hostname//**
+Network hostname.
-=== ipmtu ===
+\\
+== Returns: ==
+----
+JSON formatted table with values below
-Control Ethernet IP Maximum Transmission Unit (MTU) size in bytes
+**//ret//** Custom return code of the HTTP POST request. 0 on success, 1 on failure.
-Possible values: 576 to 1500
+**//status//** String describing the failure when **ret** is 1. "OK" on success.
+\\
 ==== SetDisplay ====

Wiki

User Tools

Site Tools

Differences

Page Tools